employee
Perm, Perm, Russian Federation
employee
Perm, Perm, Russian Federation
For determination of the surface roughness function after face milling a complete factorial experiment has been fea-tured. An adequate mathematical model of roughness and significant variables are calculated. Hypersurfaces and function level lines are projected, optimal and maximum cutting modes are found in a graphical-analytic way.
ace milling, carbide material, complete factorial experiment, roughness profile diagram, mathematical model, hypersur-face, level lines
1. Makarov, V.F. Selection and appointment of optimal conditions for broaching workpieces from difficult-to-machine materials. Perm: Publ. house of Perm State Technical Univer-sity, 2008, 396 p.
2. Grades of steels and alloys. / A.S. Zubchenko, M.M. Koloskov, Yu.V. Kashirsky, et al. Moscow: Mashinostroenie, 2003, (in Russian).
3. Kosovsky, V.L. Handbook of a milling cutter. Moscow: Higher School, publ. center "Academy", 2001, 400 p.
4. Morozov, V.V. Milling tool. Textbook, Vladimir: VlSU, 2014, 214 p.
5. Rotating tools. Milling. Sandvik Coromant: catalog, Moscow: LLC "Sandvik", 2017, 515 p.
6. Pryazhnikova, A.A. Substantiation of reasonable geometric parameters of the carbide replaceable inserts for finish-turning operation. Diss. Ph. D, 05.02.07, Tula, 2014, 203 p.
7. Spiridonov, A.A. Planning an experiment in the study of technological processes. Moscow: Mashinostroenie, 1981, 184 p.
8. Makarov, E.G. Engineering calculations in Mathcad 15, training course. St. Petersburg: Peter, 2011, 400 p.
9. Pepelyshev, A.V. Technological support of accuracy pa-rameters and roughness of flat surfaces of deep grooves by the method of raster milling on CNC machines, Diss. Ph. D, 05.02.08, Perm, 2016, 159 p.
10. Nekrasov V.N. Quality management of parts by pre-dicting the topography of the treated surface using simulation modeling on the example of end milling, Diss. Ph. D., 05.03.01, Barnaul, 2007, 136 p.
