Saratov, Saratov, Russian Federation
graduate student
Saratov, Saratov, Russian Federation
Saratov, Saratov, Russian Federation
employee
Saratov, Saratov, Russian Federation
Saratov, Saratov, Russian Federation
A new purifying method of metal surface cleaning from oxide scale using a special rotating edge tool is described, which allows to solve the problem of increasing the extent of surface purification from oxide scale more efficiently, reliably and effectively. The process of the surface cleaning of flat- rolled products used for the manufacture of hollow sheres from oxide scale by mechanical action of a cutting tool on various layers of oxide scale is simulated. The force required to shift an oxide scale and the boundary conditions of the ratio hold-down pressure of the tool to the workpiece, the friction force in the tool support and the impact force of the scale on the tool, at which it is possible to remove the scale from the rolled surface, are determined.
oxide scale, rolled products, hollow sheres, purifying method, tool, mechanical action, boundary conditions
1. Sufyanov, D.V., Ogarkov, N.N., Murzaeva, E.A. et al. Theoretical study of the process of passing a hot-rolled strip through a bending-stretching scale breaker of a continuously etching unit", Production of Flates (Proizvodstvo prokata), 2012, no. 10, pp. 31-34.
2. Rudenko, V.I., Sukov,G.S. et al. Determination of the main parameters of devices for hydraulic oxide scale removal // Metallurgical and mining industry,2004, no. 4, p. 28-30.
3. Parusov, V.V., Savyuk, A.N. et al. Investigation of the possibility of the most complete removal of oxide scale from the wire rod before drawing //Metallurg, 2004, no. 6, p. 69-72.
4. Korolev A.V., Korolev A.A. Method of surface cleaning [Sposob ochistki poverkhnosti], application 2014105408/02 Russian Federation, IPC B08B 1/04 (2006.01), appl. 13.02.2014; publ. 20.08.2015, bul. no. 23
5. Korolev, A.V., Panfilova A.V. et al. Investigation of the influence of processing modes on the efficiency of cleaning sheet metal for hollow spheres from oxide // Bulletin of the Voronezh State Technical University, 2020,Vol. 16, no. 3, p. 120-126.
6. Reshetnikova, O.P., Iznirov, B.M. et al. Determination of the value of the total error of the adjustment size during centerless grinding of balls // Science intensive technologies in mechanical engineering, 2021, no.2 (116), P. 14-19.
