employee
Russian University of Transport (Associate Professor)
Moscow, Moscow, Russian Federation
Various factors affecting shaping processes at combined processing are shown. A role of these factors and a significance of their total impact upon a surface relief is considered, the analysis of their impact is shown. The recommendations on the mode choice for fusible metal combined processing are given.
roughness, SOTS, combined processing, parameters, material, modes, cutting forces
1. Vasin, S.A. Design of Replaceable Polygon Inserts. Methodological Principles. M.: Mechanical Engineering, 2006. - pp. 352.
2. AB Sandvik Coromant Catalogue. Highcapacity Cut-ting. - M.: Polygraphy, 2003. - 2003. - pp. 301.
3. Makarov, V.F., Semikolennykh, V.V., Chigodaev, N.E., Vesnin, G.V. Intensification of edge and abrasive processing of hard-to-machine materials based on cutting physical optimi-zation // Tools and Technology. - 2004. - No.17-18. - pp. 129-135.
4. Poduraev, V.N. Hard-to-machine Material Cutting: col-lege manual. M.: Higher School, 1974. - pp. 476.
5. Breev, S.V., Serebrennikova, A.G. High-speed milling of hard-to-machine materials: Part 2. Machinability Peculiari-ties at Milling // Proceedings of Komsomolsk-upon-Amur State Technical University: Transactions. No.IV-1 (16). - 2013. - pp. 59-66.
6. Gruby, S.V., Zaitsev, A.M. Milling Technology Effec-tiveness Increase of Parts Made of Promising Aluminum Al-loys on Modern NC Machines.: http://mt2.bmstu.ru/old/BMR2010/a2/5.pdf
7. Drozdov, A.V., Kiselyov, M.G. Electro-physical and Electro-chemical Methods of Material Processing: educational edition. - Minsk: BNTU. 2009. - pp. 148.
8. Smirnov, M.S. Electro-chemical Processing with Cur-rent Pulses of Micro-Second Duration, Technological Support of GTE Parts Operation Properties. Scientific School of USA-TU / M.S. Smirnov, I.L. Agafonov, S.V. Bezrukov et al. - Ufa: USATU, 2002. - pp. 185 - 208.
9. Mo Naing U. Impact of shaping technological methods upon surface quality in aluminum alloys. The VIII-th Regional Scientif.-Pract. Stud. Conf. Branch of FSBEI HVE “Moscow State Industrial University”. - Collection. Part 1. Kineshma, 2013. - pp. 70-74.
10. Balc Nicolae, Cosma Sorin Cosmin, Kessler Julia, Mager Voicu. Research on improving the outer surface quality of the parts made by SLM. Modern Technologies in Manufac-turing (MTeM). Applied Mechanics and Materials (2015) Trans Tech Publications, Switzerland, - pp. 199-204.
11. Sukhov, D.I., Nerush, S.V., Belyakov, S.V. Mazalov, P.B. Investigation of surface layer roughness parameters and production accuracy of products of additive production // Proceedings of Higher Education Colleges. Mechanical Engineering. - 2017. - pp. 73-84.
