Volgograd State Technical University (Kafedra «Tehnologiya mashinostroeniya i prikladnaya mehanika», prof.)
Saratov, Saratov, Russian Federation
Saratov, Saratov, Russian Federation
A present state of approaches and procedures for the assessment of product manufacturability is considered. There are shown sources of information and regulatory-reference literature on types, indices and methods of part design optimization for manufacturability. Current directions in scientific investigations in the field of manufacturability assurance of a product design are presented.
product design manufacturability, product design optimization for manufacturability, methods for assessment of product design manufacturability, product manufacturability
1. RSS 14.205-83. Product Design Manufacturability. Terms and Definitions: Official Edition. Instead of RSS 18831-73. - M.: Standards Publishers, 1983.
2. RSS 14.201-83*. Assurance of Product Design Manu-facturability. General Requirements: Official Edition instead of RSS 14.201-73. - M.: Standards Publishers, 1983, - pp. 9.
3. Product Design Manufacturability: reference book / un-der the general editorship of Yu.D. Amirov. - 2-d edition revised and supplemented. - M.: Mechanical Engineering, 1990. - pp. 768.
4. MR 186-85. Product Design Manufacturability Assur-ance of Engineering and Instrument Making. Methodical Rec-ommendations: Official Edition. - M.: AURIMach, 1985. - pp. 52.
5. Yanovsky, G.A. Procedure of Design Optimization for Manufacturability and Manufacturability Assessment of Engi-neering Products and Products of Instrument Making - M.: AURIMach, 1973. - pp. 102.
6. Genkin, S.I. Methods for Assessment of Engineering Product Manufacturability. - M.: AURIMach, 1974. - pp. 173.
7. Bochkaryov, P.Yu. Assessment of Manufacturability: manual / P.Yu. Bochkaryov, L.G. Bokova. - S-Pb.: “Lan” Publishers, 2017. - pp. 132.
8. Solomentsev, Yu.M. Information-Computer Systems in Mechanical Engineering CALS-Technologies / Yu.M. Solo-mentsev, V.G. Mitrofanov, V.V. Pavlov [et al.]. - M.: Science, 2003. - pp. 292.
9. Safonov, S.V. Technological Support of Product Opera-tion Characteristics. - Voronezh: IPC VSU, 2015. - pp. 225.
10. Bazrov, B.M. Problem in support of product manufac-turability // Science Intensive Technologies in Mechanical En-gineering. - 2016. - No.4 (58). - pp. 30-34.
11. Bazrov, B.M. Manufacturability of product design and its assessment // Bulletin of Mechanical Engineering. - 2018. - No.6. - pp. 47-50.
