DESIGN OF TOOL GEOMETRICAL FORM FOR MILLING
Authors:
1.
Institute of Design and Engineering Informatics of the Russian Academy of Sciences
(Leading Researcher)
Russian University of Transport (RUT (MIIT)) (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
Russian University of Transport (RUT (MIIT)) (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
2.
Rossiyskiy universitet transporta
Russian Federation
Russian Federation
Type:
Article
Pages:
from 9
to 15
Status:
Published
Received:
21.11.2018
Accepted:
08.12.2018
Published:
08.12.2018
Subject area:
UDK 62 Инженерное дело. Техника в целом. Транспорт
Language:
Russian, English
Keywords:
metal cutting, cutter, tool tip, milling
Abstract (English):
The paper reports the method for tool geometrical parameter computation for outer surface machining in solids of rotation by milling. The advantage of this method of machining is shown. The formulae for the curvature radius computation in a tool tip of the tool used in milling are presented. The formulae for the computation of a front clearance angle and a back angle in an actual plane are shown.
The paper reports the method for tool geometrical parameter computation for outer surface machining in solids of rotation by milling. The advantage of this method of machining is shown. The formulae for the curvature radius computation in a tool tip of the tool used in milling are presented. The formulae for the computation of a front clearance angle and a back angle in an actual plane are shown.
Keywords:
metal cutting, cutter, tool tip, milling
metal cutting, cutter, tool tip, milling
1. Kulikov, M.Yu., Volkov, D.V., Sklyarov, V.M. Devel-opment of tool tip efficient shape for milling // Metal Processing. - 2018. - No.3(105). - pp. 9-12.
2. Granovsky, G.I., GranovskyV.G. Metal Cutting. - M.: Higher School. 1985. - pp. 304.
3. Arshinov, V.A., Alexeev, G.A. Metal Cutting and Cut-ter. - M.: Mechanical Engineering, 1975. - pp. 440.
