MANUFACTURABILITY FACTOR ANALYSIS OF PRODUCT DESIGN FULFILLMENT
Authors:
1.
Blagonravov FSBIS IMACH RAS
(Chief researcher)
Moskva, Russian Federation
Moskva, Russian Federation
2.
FGBUN IMASh RAN im. Blagonravova
(Post graduate student)
Moskva, Moscow, Russian Federation
Moskva, Moscow, Russian Federation
Type:
Article
Pages:
from 23
to 26
Status:
Published
Received:
25.06.2018
Accepted:
14.07.2018
Published:
14.07.2018
Subject area:
UDK 62 Инженерное дело. Техника в целом. Транспорт
Language:
Russian, English
Keywords:
part, manufacturability, factors, standardization, unification, repeatability, typification
Abstract (English):
In the paper there is presented a type and characteristic classification of parts based on the variety of product design fulfillment. The analysis of manufacturability coefficients is carried out to which belong coefficients of standardization, unification, repeatability and typification. Their tie with the labour-intensiveness of design-technological pre-production and labour-intensiveness of part machining is defined. There are shown drawbacks of the coefficients considered, for instances, in coefficients of standardization and unification one does not take into account different degrees of influence upon labour-intensiveness of constituents of these coefficients, besides, a repeated account of standard parts takes place. In the coefficients of typification and repeatability both variety of parts and their number in one group of items or one standard representative are not taken into account.
In the paper there is presented a type and characteristic classification of parts based on the variety of product design fulfillment. The analysis of manufacturability coefficients is carried out to which belong coefficients of standardization, unification, repeatability and typification. Their tie with the labour-intensiveness of design-technological pre-production and labour-intensiveness of part machining is defined. There are shown drawbacks of the coefficients considered, for instances, in coefficients of standardization and unification one does not take into account different degrees of influence upon labour-intensiveness of constituents of these coefficients, besides, a repeated account of standard parts takes place. In the coefficients of typification and repeatability both variety of parts and their number in one group of items or one standard representative are not taken into account.
Keywords:
part, manufacturability, factors, standardization, unification, repeatability, typification
part, manufacturability, factors, standardization, unification, repeatability, typification
1. RSS 14.205-83 “Manufacturability of Product Design”.
2. Procedure of Design Updating for Manufacturability and Assessment of Manufacturability Level of Parts of Me-chanical Engineering. - M.: Publishing House of Standards, 1976. - pp. 56.
3. Amirov, Yu.D., Alfyorova, T.K., Volkov, P.N. Manu-facturability of Product Design: reference book. - M.: Me-chanical Engineering, 1985. - pp. 368.
4. Bazrov, B.M., Troitsky, A.A. Analysis of method for assessment of product design manufacturability as subject of manufacturing // Reference Book. Engineering Journal with Application. - 2017. - No.4 (241). - pp. 39-43.
