Moskva, Moscow, Russian Federation
Moskva, Moscow, Russian Federation
Moskva, Moscow, Russian Federation
The investigations of energetic characteristics of an erosion pulse and geometric parameters of single erosion dimples at the application of discharge low-energy pulses are carried out. A non-linear dependence of pulse energy upon its length under given conditions is shown. On the basis of the experiment results a value of the factor of electro-erosion workability for steel 12Ch18N10T is specified.
electro-erosion machining, single electro-erosion dimple, factor of electro-erosion workability
1. Tao J. Modeling of the anode crater in electrical dis-charge machining / J. Tao, J. Ni, A.J. Shih // Trans ASME. J. Manuf. Sci. and Eng. - 2012. № 1, 134. - P. 1 - 11.
2. Stavitsky, B.I. From History of Material Spark Machining / B.I. Stavitsky. − Kharkov: ChF “CenterInform”, 2013. - pp. 104.
3. Gudkova, O.S., Blinova, T.A. Analysis of methods for manufacturing small holes in stainless steel parts // The Inter. Scientific-Tech. Conf. “Investigations and Innovations in College”, Belgorod, 2012: Proceedings. - 2012. Part 2. pp. 320 - 323. 4. Science Intensive Techniques of Engineering Production. Physico-Chemical Methods and Techniques: Textbook / Yu.A. Morgunov, D.V. Panov, B.P. Saushkin, S.B. Saushkin / under the editorship of B.P. Saushkin. - M.: Forum, 2013. - pp. 928.
4. Naukoemkie tehnologii mashinostroitel'nogo proizvodstva. Fiziko-himicheskie metody i tehnologii: ucheb. posobie / Yu.A. Morgunov, D.V. Panov, B.P. Saushkin, S.B. Saushkin / Pod red. B.P.Saushkina. - M.: Forum, 2013. − 928 s.
5. Yeliseev, Yu.S., Saushkin, B.P. Electro-erosion Treat-ment of Parts of Aero-space Engineering / under the editorship of B.P. Saushkin - M.: Publishing House of Bauman STU of Moscow, 2010. - pp. 437.
