UDC 621.924.9.023

ENGINEERING SUPPORT AND IMPROVEMENT OF THE QUALITY OF WORKPIECES OBTAINED BY PRESSURE METAL TREATMENT Engineering support and improvement of the quality of workpieces obtained by pressure metal treatment

Published in Science intensive technologies in mechanical engineering · Volume 2022, Issue 8 · Pages 12–19 · Rubric: Technology and equipment of metal processing by pressure
DOI: https://doi.org/10.30987/2223-4608-2022-8-12-19
Received: 20.08.2022 Accepted: 30.08.2022 Published: 30.08.2022
The article presents the analysis of the geometric quality of products obtained by sheet-metal forming. In particular, the resultant expressions are shown, making it possible to assay the damage and bifurcation within metal workpieces deformation
form alteration, bifurcation, damage rate, cold forming
Text References
Text (PDF)
Read Download

1. Popov E.A. Osnovy teorii listovoy shtampovki [The Theoretical Fundamentals of sheet stamping] Moscow: Mashinostroenie, 1968. 283 p. (in Russian).

2. Bogatov A.A., Mizhiritsky O.I., Smirnov S.V. Resurs plastichnosti metallov pri obrabotke davleniem [Resource of metal plasticity under pres-sure treatment], Moscow: Metallurgiya, 1984, 144 p. (in Russian).

3. Storozhev M.V., Popov E.A. Teoriya obrabotki metallov davleniem [The theory of processing of metals pressure], Moscow: Mashinostroenie, 1977,423 p. (in Russian).

4. Nechepurenko Yu.G., Yakovlev S.P., Yakovlev S.S. Deep drawing of cylindrical products from an anisotropic material. Tula: Tula State University, 2000, 195p.

5. Theory of metal processing by pressure / ed. By Golenkova V.A., et al. / Moscow: Mashinostroenie, 2009, 442 p.