APPLICATION OF THE NX AND E3 SERIES PROGRAMS FOR ELECTRICAL ROUTING OF WIRING AND HARNESS
Authors:
1.
Kazan National Research Technical University named after A.N. Tupolev
2.
Kazan National Research Technical University named after A.N. Tupolev
Type:
Сonference article
Published:
20.02.2020
Subject area:
UDK 62 Инженерное дело. Техника в целом. Транспорт
GRNTI 47.01 Общие вопросы электроники и радиотехники
BBK 302 Проектирование
GRNTI 47.01 Общие вопросы электроники и радиотехники
BBK 302 Проектирование
Language:
Russian
Keywords:
production, modernization, NX, E3 Series, wires, harnesses
Abstract (English):
This work is devoted to the analysis of the possibility of using modern software to modernize production. NX and E3 Series programs are available as suggested options. The analysis of the work of these programs is made and options for their use are proposed.
This work is devoted to the analysis of the possibility of using modern software to modernize production. NX and E3 Series programs are available as suggested options. The analysis of the work of these programs is made and options for their use are proposed.
Keywords:
production, modernization, NX, E3 Series, wires, harnesses
production, modernization, NX, E3 Series, wires, harnesses
1. Vedmid', P.A. Programmirovanie obrabotki v NX CAM / P.A. Vedmid', A.V. Sulinov. - M.: DMK Press, 2014. - 304 s.
2. Artamonov, I.A. NX Advanced Simulation: prakticheskoe posobie / I.A. Artamonov, P.S. Goncharov, S.V. Denisihin, D.E. Sotnik, T.F. Halitov. - M.: DMK Press, 2014. - 114 s.
