THREAD-CUTTING PECULIARITIES IN HOLES WITH ULTRA-SMALL DIAMETERS
Rubrics: MECHANICAL ENGINEERING AND TRANSPORT
Authors:
1.
Institute of Design and Engineering Informatics of the Russian Academy of Sciences
(Leading Researcher)
employee
Russian University of Transport (MIIT) (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
employee
Russian University of Transport (MIIT) (Department of Technology of Transport Engineering and Repair of Rolling Stock, Professor)
employee
Moscow, Moscow, Russian Federation
2.
Institute of Design Technological Informatics of RAS
(Post graduate student)
graduate student
Moskva, Moscow, Russian Federation
graduate student
Moskva, Moscow, Russian Federation
Type:
Article
Pages:
from 153
to 156
Status:
Published
Received:
12.10.2016
Accepted:
12.10.2016
Published:
12.10.2016
Language:
Russian
Keywords:
thread-cutting, ultra-small diameter, fine turning, cuttings section
Abstract (English):
The process of threadcutting process in holes with ultrasmall diameters is considered. It is revealed that because of the peculiarities arisen the thread-cutting conditions become tougher and bending loads in a tap operating arise.
The process of threadcutting process in holes with ultrasmall diameters is considered. It is revealed that because of the peculiarities arisen the thread-cutting conditions become tougher and bending loads in a tap operating arise.
Keywords:
thread-cutting, ultra-small diameter, fine turning, cuttings section
thread-cutting, ultra-small diameter, fine turning, cuttings section
1. Kulikov, М.Yu. Reliability investigation of thread-cutting process in holes with ultra-small diameters / М.Yu. Kulikov, М.V. Yagodkin // Proceedings of KSU. - 2015. - №5. - pp. 61-62.
2. Rykunov, А.N. Peculiarities of wearresistant tool coatings at fine turning / А.N. Rykunov // Reference Book. Engineering Journal. - 2000. - №4. - pp. 10-11.
3. Rykunov, А.N. Fine Turning. Simulator, Mode Limits, Physical Peculiarities and Process Technological Potentialities / А.N. Rykunov. - Rybinsk: RSATA, 2003. - pp. 258.
4. Rukunov, А.N. Thermalphysic analysis of edge cutting machining with small thick shears / А.N. Rykunov //Bulletin of VVO ATN RF. - 2010. - №1. - pp. 128-134.
