The physical picture of the process electroerosive processing on the basis of which identified the main factors (voltage, current strength, pulse duration, the coefficient of using the pulse energies, properties of dielectric liquids, material and tool material, the temperature in the layer blank, the original settings of the waviness of the workpiece and tool), which influence on the process of formation of the parameters of roughness, waviness, microhardness and technology of residual stresses.
surface, the surface roughness, the sinuosity of a surface, residual stress, microhardness, electrical discharge machining.
1. Sjyanov, S.YU. Correlation of electrophysical processing parameters with indicators of surface quality, wear of the tool and processing productivity / S.Yu. Sjyanov // Bulletin of Bryansk State Technical University. - 2008. - No. 1 (17). - pp. 14-19.
2. Sjyanov, S.Yu. Determination of residual tension, wear of the tool and productivity in case of electro machining / S. Yu. Sjyanov // Bulletin of Bryansk State Technical University.-2006. - No. 2. - pp. 59-61.
3. Sjyanov, S.Yu. Correlation of microhardness and residual tension with electro machining parameters / S. Yu. Sjyanov//Science and education of the 21st century: Proceedings of Inter. Science-Tech. Conf. - 2013. - pp. 237-240.
4. Sjyanov, S.Yu. Technological control of quality parameters of the surface layers of machine parts when electro machining / S. Yu. Sjyanov // High-tech technology in mechanical engineering. - 2014. - No. 6 (36). - pp. 24-29.
5. Fedonin, O. N. Control of tool wear and process productivity a when electromachining / O. N. Fedonin, S.Yu. Sjyanov, N. I. Fomchenkova//Bulletin of Bryansk State Technical University. - 2014. - No. 3. - pp. 85-88.
6. Makarov, V. F. Optimization of accelerated electro-erosion drilling process of holes of small diameters in parts from heat resisting alloys / V. F. Makarov, R. S. Abzayev, A.V. Vladykin // Reference Book. Engineering journal. - 2013. - No. 7(196). - pp. 8 - 13.85-88.
